improve OpenBSD pledge call

[ust.git] / README.md

diff --git a/README.md b/README.md
index ed51c114753192da7c336fa13303348f8c33cde0..44d3f5058d8f62fea6e1940372275700849776c8 100644 (file)
--- a/README.md
+++ b/README.md
@@ -1,56 +1,9 @@
-## Flags
+## Installation
 
-All flags can have their default values set by modifying `config.h`, additional info and configuration options are also available in the file
+Before installing check `config.mk` - inside, the installation directories can be set.
 
- * `--line|-l line` - line (device) to open, can be specified with `/dev/` or as just the device name
- * `--verbose|-v` - toggle verbose output
- * `--speed|-s # | -#` - set baudrate
- * `--rx-speed|-i` - set separate baudrate for RX line, same as TX if not set explicitly
- * `--data|-D bits` - set data bits
- * `--stop-bits|-S bits` - set stop bits 
- * `--software|-X` - toggle XON/XOFF flow control
- * `--delay|-d delay` - delay between sending characters (in nanoseconds)
- * `--min-chars|-m` - the minimal number of characters to start sending to the line
- * `--backspace|-b` - toggle between ASCII `DELETE` and `BACKSPACE` characters for backspace key
- * `--echo|-h` - toggle local echo (half-duplex mode)
- * `--canonical|-c` - toggle canonical mode (text can be edited locally before sending it to the line)
+To install, simply run:
 
-> If both even and odd parity flags are set, parity is disabled
-
- * `--odd|-o` - toggle odd parity
- * `--even|-e` - toggle even parity
-
-> If both hardware flow control flags are set, DCD flow control is enabled
-
- * `--hardware-rts-cts|-R` - toggle RTS/CTS flow control
- * `--hardware-dtr-dsr|-r` - toggle DTR/DSR flow control
-
-> Multiple translation options should be specified with multiple flags, e.g., `-t no-cr -t no-lf`  
-
- * `--translation|-t option` - CR and LF translation for data sent
- * `--input-translation|-T option` - CR and LF translation for data read
-
-### Options:
-
- * `cr-to-lf`
- * `cr-in-lf` - CR to CRLF
- * `no-cr`
- * `lf-to-cr`
- * `lf-in-cr` - LF to CRLF
- * `no-lf`
-
-## Interactive use
-
-Special character (`~` by default, may be set in `config.h`) will be escaped if it's the first one in the buffer.
-
-### Commands
-
- * `.` - drop connection and exit
- * `b` - toggle backspace character between the two
- * `h` - toggle local echo
- * `c` - toggle canonical mode
- * `s` - set new baudrate
- * `d` - set new character delay
- * `t|T` - toggle a translation option for output|input
- * `w` - write file contents to the line
- * `p` - send a DCD pulse
+```
+make && make install
+```